LUXWAVE

Energy follows actual occupancy.

Lighting, heating and ventilation adjust to occupancy measured zone by zone, not to a schedule. And every kilowatt-hour is linked to a place and a use.

Status
On demonstration
Where to see it
Occupancy measurement on a demonstrator site
Who it is for
Energy, property, operations
Reception“Can you hear me?”Offices“Can you hear me?”Storeroom“Can you hear me?”Workshop“Can you hear me?”Plant room“Can you hear me?”

What?

Empty rooms get heated, ventilated and lit.

On the ground

Most buildings run on fixed schedules, as if they were full. Doing better takes a reliable measure of occupancy, and that is what is missing: the CO₂ sensor reacts late, the presence detector does not count, the camera raises a privacy problem.

With LUXWAVE

LUXWAVE measures presence where it is: under each light. The network knows which zones are occupied, and by how many badges. The lighting adjusts itself; heating and ventilation receive the information through the building management system.

  • Measured occupancyBy zone and by hour, with no cameras and no images.
  • Lighting that adjusts itselfThe Point Service controls the luminaire: lights on when people arrive, off in empty zones.
  • Energy linked to placesEvery kilowatt-hour has a zone and a time.

How?

The Point Service measures and controls.

Housed in the luminaire, the Point Service picks up the badges present and controls the lighting: scenes, dimming, lights on when people arrive. For people without a badge, a presence detector completes the measurement. Occupancy is sent to your building management system through open interfaces.

How it works, in detail

The hardware

  • On demonstrationPoint ServiceIn the luminaire, as a retrofit or in new build. It emits the zone’s address.
  • On demonstrationBadgeWorn by the person. It reads the address in the light.
  • On demonstrationGatewayConnects the lighting network to your servers.

Project economics

  • Low investmentNo anchors, no data cabling: the Point Service fits inside the luminaire.
  • Quick commissioningThe lighting plan is already the zone plan. Nothing to calibrate room by room.
  • Very little maintenanceEach Point Service is powered by the lighting.
  • Reduced operating costsOne subscription per device, offered by our lighting and integrator partners.
  • A fast paybackControlled lighting reduces the energy bill and pays for the infrastructure.

Why?

Energy savings pay for the infrastructure.

  • A lower lighting billEmpty zones are no longer lit.
  • Accurate setpointsHeating and ventilation receive actual occupancy, not an estimate.
  • Data for your obligationsFrance’s Décret tertiaire, building automation and control requirements: dated occupancy, zone by zone.
  • No camerasOccupancy measurement produces no images.

−49%

in lighting energy on average with networked lighting controls, measured across 194 buildings.

Source: Northwest Energy Efficiency Alliance and DesignLights Consortium, 2020. Figure published by a third party, not a LUXWAVE result.
What you measure from day one
  • Occupancy rate by zone
  • kWh by zone and by hour
  • Lighting hours avoided
  • Gap between schedule and occupancy

What next?

See the light at work.

A demonstration on site or remotely, based on your lighting plans.

The location, what you want to solve, your timescales: enough to prepare the demonstration. 1,500 characters at most.
Answer in digits.